EasyManuals Logo

Suzuki GSR600 User Manual

Suzuki GSR600
230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
ENGINE 3-65
CRANKSHAFT THRUST BEARING
With the crankshaft, right-side thrust bearing and left-side
thrust bearing inserted in the upper crankcase, measure the
thrust clearance on the left side by using the thickness gauge.
L: Left-side thrust bearing
R: Right-side thrust bearing
NOTE:
Pull the crankshaft to the generator side, so that there is no
clearance on the right-side thrust bearing.
Thrust clearance:
Standard: 0.055 – 0.110 mm
09900-20803: Thickness gauge
If the thrust clearance exceeds the standard range, adjust the
thrust clearance by the following procedures.
CRANKSHAFT THRUST CLEARANCE ADJUSTMENT
Remove the right-side thrust bearing and measure its thick-
ness with a micrometer.
If the thickness of the right-side thrust bearing is below stan-
dard, replace it with a new one and once again perform the
thrust clearance measurement listed above, checking to
make sure it is within standard.
Right-side thrust bearing thickness:
Standard: 2.425 – 2.450 mm
09900-20205: Micrometer (0 – 25 mm)
If the right-side thrust bearing is within the standard range,
reinsert the right-side thrust bearing and remove the left-side
thrust bearing.
As shown in the illustration, measure the clearance by using a
thickness gauge before inserting of the left-side thrust bear-
ing.
Select a left-side thrust bearing from the selection table.
(3-66)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki GSR600 and is the answer not in the manual?

Suzuki GSR600 Specifications

General IconGeneral
Engine Type4-stroke, 4-cylinder, liquid-cooled, DOHC
Displacement599 cc
Compression Ratio12.5:1
Fuel SystemFuel injection
IgnitionElectronic ignition (transistorized)
LubricationWet sump
StarterElectric
Transmission6-speed, constant mesh
Final DriveChain
Front SuspensionTelescopic, coil spring, oil damped
Rear SuspensionLink type, coil spring, oil damped
Front BrakesDual hydraulic disc
Rear BrakesSingle hydraulic disc
Front Tire120/70ZR17M/C (58W), tubeless
Rear Tire180/55ZR17M/C (73W), tubeless
Bore x Stroke67.0 mm x 42.5 mm
Overall Length2, 090 mm
Overall Width795 mm
Wheelbase1440 mm
Ground Clearance130 mm
Seat Height785 mm
Fuel Tank Capacity16.5 L

Related product manuals