3-42 ENGINE
• If a large resistance is felt for rotation, inspect the starter
clutch bearing or the starter clutch contacting surface on the
starter driven gear for wear and damage.
• If they are found to be damaged, replace them with the new
ones.
GENERATOR
INSPECTION (9-10)
REASSEMBLY
• When installing the generator stator set bolts, tighten them to
the specified torque.
Generator stator set bolt: 10 N·m (1.0 kgf-m)
NOTE:
Be sure to install the grommet
1
to the generator cover.
To Next Page
Loading...
Need help?
General
