FI SYSTEM DIAGNOSIS 4-23
NOTE:
The above form is a standard sample. The form should be modified according to conditions and characteris-
tics of each market.
VISUAL INSPECTION
• Prior to diagnosis using the mode select switch or SDS, perform the following visual inspections. The rea-
son for visual inspection is that mechanical failures (such as oil leakage) cannot be displayed on the panel
with the use of mode select switch or SDS.
* Engine oil level and leakage (2-13)
* Engine coolant level and leakage (2-17 and -18)
* Fuel level and leakage (
2-14 and 9-33)
* Clogged air cleaner element (2-4)
* Battery condition (9-42)
* Throttle cable play (2-15)
* Vacuum hoses looseness, bend and disconnection
* Burnt fuse
* FI light operation (4-16, 9-29 and -31)
* Each warning light operation (9-31)
* Speedometer operation (9-34)
* Exhaust gas leakage and noise (2-28)
* Each coupler disconnection
* Clogged radiator fins (7-4)
MOTORCYCLE/ENVIRONMENTAL CONDITION WHEN PROBLEM OCCURS
Environmental condition
Weather
Fair Cloudy Rain Snow Always Other
Temperature Hot Warm Cool Cold ( °C) Always
Frequency Always Sometimes ( times/ day, month) Only once
Under certain condition
Road Urban Suburb Highway Mountainous ( Uphill Downhill)
Tarmacadam Gravel Other
Motorcycle condition
Engine condition
Cold Warming up phase Warmed up Always Other at starting
Immediately after start Racing without load Engine speed ( r/min)
Motorcycle con-
dition
During driving: Constant speed Accelerating Decelerating
Right hand corner Left hand corner
At stop Motorcycle speed when problem occurs ( km/h, mile/h)
Other
To Next Page
Loading...
Need help?
General
