3-20
OPERATING YOUR VEHICLE
80SS5-01E
GPF warning light
64J244
If the GPF warning light comes on when
driving, the GPF is nearly clogged. You
should regenerate the GPF when the GPF
warning light comes on. To go out the
warning light, the vehicle must stay in
motion until regeneration has been com-
pleted.
The process normally takes about 25 min-
utes.
The optimum condition to end the process
are achieved by keeping the vehicle in
motion at a speed of 50 km/h (31 mph) or
higher, and an engine speed higher than
2,000 rpm.
However, you should drive carefully and
within the legal speed limit, and should
take in to consideration the surrounding
traffic condition.
If you drive your vehicle until the light goes
out, the regeneration of the GPF will be
completed.
Using transmission
Manual transmission
5MT model
79MH0303
NOTICE
Be sure to regenerate the GPF when
the GPF warning light comes on. Fail-
ure to regenerate the GPF will cause
a vehicle malfunction due to the
clogged filter.
WARNING
Do not hang any items on the gear-
shift lever and do not use the gear-
shift lever as a handrest. Otherwise,
it could prevent proper operation of
the gearshift lever and cause its mal-
function, resulting in an accident.
To Next Page
Loading...
Need help?
General
