7-47
INSPECTION AND MAINTENANCE
80SS5-01E
If the coolant level is below the “LOW”
mark, more coolant should be added.
When the engine is cool, remove the
degassing tank cap by turning it anticlock-
wise slowly to release any pressure. And
add coolant until the degassing tank level
reaches the “FULL” mark. Never fill the
degassing tank above the “FULL” mark.
Coolant replacement
Since special procedures are required, ask
an authorized SUZUKI dealer for this job.
Air cleaner
If the air cleaner is clogged with dust, there
will be greater intake resistance, resulting
in decreased power output and increased
fuel consumption.
(For K10C engine model)
Since special procedures, materials and
tools are required, it is recommended that
you trust this job to an authorized SUZUKI
dealer.
(For K12C engine model)
52RM70100
(For K12M engine model)
52RS70040
1) Unclamp the side clamps (1).
2) Hold up and pull the air cleaner upper
case toward you.
3) Remove the element from the air
cleaner case. If it appears to be dirty,
clean or replace it with a new one.
4) Clamp the side clamps securely.
WARNING
It is hazardous to remove the reser-
voir tank cap (degassing tank cap)
when the water temperature is high,
because scalding fluid and steam
may be blown out under pressure.
Wait until the coolant temperature
has lowered before removing the cap.
(1)
To Next Page
Loading...
Need help?
General
