6.6
Speed Code
This function is to change the embroidery speed from high speed to low speed for a particular part of embroidery
work. When conducting embroidery of the same design from the beginning, the speed change will occur at the
embroidery part where the speed change was previously set.
<Fig. 6.5-1> appears when of the menu during embroidery pause is pressed and the speed code
menu is selected.
Low Speed Code
This function is to change the embroidery speed from high speed to low speed.
Pause the high-speed embroidery work and select “Low Speed” and press “Set”. Then when embroidery work is
resumed, its speed becomes slow.
High Speed Code
This function is to change the embroidery speed from low speed to high speed. Pause the low-speed
embroidery work and select “High Speed” and press “Set”. When the start button is pressed, the embroidery
speed becomes fast.
Reset
This function is to initialize the speeds set for particular sections to default speed.
[Fig. 6.6-1]
To Next Page
Loading...
Need help?
General
