40
PROGRAMMING
Line 1 of the rst brew group control screen indicates the current temperature of the brew tank as measured
by its probe. Once this temperature reaches the set point, it will connuously cycle up and down by small
increments as the electronics balance the temperature. This line also indicates the acve program (PRG1 in
this case). Changing the acve program will update the sengs on the lines below.
Line 2 is indicang the set point of 202.0°F (94.4°C).
Line 3 indicates the length of me preinfusion is set for in the current program. When starng a shot in MP or
VP mode, preinfusion will allow line pressure water to soak the puck for as long as indicated before moving
on to the next brew phase. Seng the preinfusion me down to 0.0 seconds will skip the preinfusion phase
in MP and VP modes. One step lower than 0.0 is the “MAN” seng, which will require the operator to exit
the preinfusion phase manually in MP mode, and will skip preinfusion in VP mode.
Line 4 indicates the length me set for the ramp-up phase in the current program. This opon will ONLY be
visible on MVP Hydra models. Ramp-up me begins once the preinfusion stage has nished.
To cycle to the next display screen, press the down buon.
Menu Level 1: Group 1, Program 1
Factory Sengs:
The factory sengs for MVP Series machines are as follows:
Brew Group Temperature 203°F
Steam Tank Temperature 250°F
Brew Mode M (Manual)
Right-Hold Save Lockout Locked (To Unlock refer to page 51)
Enabled Programs 1 & 2 Enabled (3-6 Disabled)
Temperature Units Fahrenheit
Program 1: Program 2:
Preinfusion 4 seconds Preinfusion 4 seconds
Ramp Up 2 seconds Ramp Up 2 seconds
Ramp Down 92% Ramp Down 92%
Total Water Count 280 Total Water Count 380
To Next Page
Loading...
Need help?
General
