6
RECOMMENDED TOOLS & SUPPLIES
• Mul Meter – reads volts, amps and ohms
(The Fluke T5-600 is recommended)
• Heat Shrink Gun or Torch
• Vacuum with a Hose
• Compressed Air
• Descaler – Citric Acid
• Flashlight
• Box Knife
• Thread Sealant – Red and Blue Locte
• Food Grade Grease (Super Lube) 1.8600
• Tube Bender for 1/4”, 5/16”, and 3/8” Tube
• Flare Tool - 45°
• Tube Cuer
• Brass Bristle Wire Brush
• 3/8” Drive Socket Wrench with 7/16”, 1/2”
and 9/16” “Deep Sockets”
• Hammer Medium Size Ball Peen
• Wire Stripper / Crimper
• Small Punch and Chisel
• Small Files – Round and Triangular
• Picks – Straight and Curved, an Ice Pick is great for
replacing portalter gaskets
• Dies: 1/8” NPT, 1/4” NPT, and 1/8” BSPP
• Taps: 8-32, 10 - 32, 3/8 – 16, and M6 x 1
booming Tap
• Allen Wrenches: 3/32”, 1/8”, 9/64”, 5/32, 3/16”,
1/4” (steam valve seat)
• Wrenches: 2x11/32, 1/4, 5/16, 3/8, 2x7/16, 1/2,
2x9/16 , 5/8, 11/16, 3/4, 12mm & 17mm
• Adjustable wrenches: Medium size 1 1/4”
opening and Small for ght spots
• Pliers: Channel Lock, Standard pliers and Side
Cuers
• Philips Head Screwdrivers: #2 short, #2 long and
#1
• Flat Head Screwdrivers: #2 short, #2 medium
length, #1 medium, #0 medium
• A large at head screwdriver (or small at nail
puller) to use as a pry bar or wedge.
• Pen and paper
Tools and recommended items required to fully diagnose, service and maintain
Synesso espresso machines.
START UP SCREEN
Understanding the informaon displayed in the serial number i.e.: 301142030
3 - is the number of groups on this machine (this is a 3 group machine)
01 - is the month the machine was built (Jan is 01)
14- is the year it was built (14 is the year 2014) & 2030 is the machine sequence number
When cycling the power on,
this screen is shown momen-
tarily . It displays your soware
version and your serial number.
To Next Page
Loading...
Need help?
General
