5-39
MAINTENANCE
EVERY 250 HOURS
INSPECTING THE THROTTLE CONTROL
SYSTEM
Operate the throttle controller to check for
stretch in the wire and looseness of it at the
fixing portion.
If the wire is stretched or loosened at the
fixing portion, malfunction could result.
The operation of wire replacement or
adjustment requires experience. Ask your
sales or service dealer for it.
1. Turn the starter switch to the ON position.
Check that the governor lever (1) is
contacting the low-speed limit bolt (2).
2. Press the Deceleration button to cancel
the deceleration mode. Turn the throttle
controller to the maximum speed position,
and check that the governor lever (1) is
contacting the high-speed limit bolt (3).
If the governor lever is not contacting
either the limit bolt (1) or (2), contact your
sales or service dealer for help.
To Next Page
Loading...
Need help?
General
