Network Meter Block Installation, Operation, & Maintenance Manual
Introduction 2
1.2 Included Equipment
1.2.1 Integral Equipment
The following equipment is integral on the NMB:
• Two RJ45 port connections
• Three-port switch for ETH1, ETH2, and an internal processor
• Light-emitting diode (LED) for port speed and activity
1.2.2 Ancillary Equipment
The following ancillary equipment is included with the NMB:
• 10/100Base-TX Ethernet cable (based on IEEE 802.3 standards)
1.3 Receipt of Equipment
When you receive your NMB, you should check the exterior packing case for any shipping damage.
Carefully remove the unit from the exterior packing case and inspect it for damaged or missing parts.
Ensure you received your purchased options. For details about NMB models and optional accessories,
see Table 1: NMB Model Codes.
Prior to installation, the unit should be stored in its original packing case and protected from adverse
weather conditions and abuse.
1.4 Storage Instructions
To ensure your NMB is not corroded or damaged by moisture or water before being installed, it must be
properly stored using the following instructions:
• Keep the unit in a dry, protected location.
• Avoid storing the unit outside; if you must store it outside, ensure it is protected from the elements.
• For NMBs purchased with an instrument housing, use the following additional storage guidelines:
If the packing case is damaged, contact the shipping carrier immediately regarding their liability.
If the NMB is damaged or parts are missing, a written report must be submitted to:
TechnipFMC
c/o Inside Sales Department, Measurement & Production Solutions
PO Box 10428
Erie, PA 16514
To Next Page
Loading...
Need help?
General
