Network Meter Block Installation, Operation, & Maintenance Manual
Introduction 4
1.5.3 Electrostatic Discharge Precautions
Electronic components are susceptible to damage by static discharge. To minimize the risk of damage, the
following precautions should be followed:
• Before touching a circuit board with hands or tools, personnel and tools should be grounded using a
wrist strap.
• Avoid touching components or traces on the circuit boards and handle by the edges or mounting holes.
• Circuit boards should be kept in conductive bags when not installed.
1.5.4 RF Radiation
The NMB generates, uses, and can radiate radio frequency (RF) energy and, if not installed and used in
accordance with this manual, may cause interference to radio communications. It has not been tested to
comply with the limits pursuant to the Federal Communications Commission’s (FCC) Code of Federal
Regulations, Title 47, Part 15 (47 CFR 15), as electronic control equipment used by an industrial complex
is exempt from these rules.
Operation of this equipment in a residential area may cause interference, in which case the user, at their
own expense, will be required to take whatever measures that may be required to correct the interference.
1.5.5 Weights & Measures Requirements
The NMB is a device that is marketed for a global market. Requirements regarding weights and measures
may vary depending on the region. Users are required to verify that the device is configured and operated
in a manner consistent with local codes and that proper notification (permit for use) or registration has
been filed with the local authority or jurisdiction for this type of device if used to transmit legally relevant
data. This device is intended as a diagnostic tool.
To Next Page
Loading...
Need help?
General
