Specification—2465B/2467B Service
Table 1-2 (cont)
Characteristics Performance Requirements
ADDED DELTA-DELAY-TIME CHARACTERISTICS WITH C/T/T
Run After Delay
Accuracy
Triggerable After Delay
Accuracy
Superimposed Delta Time
Nonsuperimposed Delta Time
Display Update Rate
LSD
b
+ [0.0008 X (A SEC/DIV)] + [0.01 X (B Time/Div)
c
] + 83
ps.
When the A Sweep is triggered by the Word Recognizer in
synchronous mode, add 1 ns for probe jitter; in asynchronous
mode,
add 20 ns for probe jitter.
Both delays are within 70 ns to 10 times the A-SEC/DIV setting.
LSD
b
+ [0.01 x (B Time/Div)
c
] + [10 ppm x (A SEC/DIV)] + [10
ppm x (measured interval)] + 50 ps + TJE.
If CH 3 or CH 4 is one channel of a two-channel measurement, add
0.5 ns for channel-to-channel delay mismatch.
LSD
b
+
lt
rREF
-t
rDELT
l< + TJE
+
[(0.0005 div) x (1/SR
REF
+
1/SR
DELT
)]
+
[10 ppm x (A SEC/DIV)] +
[10 ppm x (measured interval)] + 50 ps.
If A and B sweeps are triggered from different channels, add 0.5 ns
for channel-to-channel mismatch + [0.5 div x (1/SR
REF
+
1/SR
DELT
)]
for trigger offset.
In Auto Resolution, twice per second or once for every four
sweeps, whichever is slower.
In 1 ns, 100 ps, and 10 ps resolution modes, the update rate
depends on the A SEC/DIV setting and the trigger repetition rate.
b
See Tables 1-3 and 1-4.
C
B Time/Div includes SEC/DIV, X10 MAG, and VAR.
d
This term assumes the trigger points are between the 10% and 90% points of the waveforms. Fall time is expressed as a negative
risetime.
1-17
To Next Page
Loading...
Need help?
General
