Tektronix 2465B Service Manual

Section 11 - 2465B/2467B Service
REPLACEABLE
MECHANICAL PARTS
PARTS ORDERING INFORMATION INDENTATION SYSTEM
Replacement parts are available from or through your lo-
cal Tektronix, Inc. Field Office or representative.
Changes to Tektronix instruments are sometimes made
to accommodate improved components as they become
available, and to give you the benefit of the latest circuit im-
provements developed in our engineering department. It is
therefore important, when ordering parts, to include the fol-
lowing information in your order: Part number, instrument
type or number, serial number, and modification number if
applicable.
If a part you have ordered has been replaced with a new
or improved part, your local Tektronix, Inc. Field Office or
representative will contact you concerning any change in
part number.
Change information, if any, is located at the rear of this
manual.
ITEM NAME
In the Parts List, an item Name is separated from the
description by a colon(:). Because of space limitations, an
Item Name may sometimes appear as incomplete. For fur-
ther Item Name identification, the U.S. Federal Cataloging
Handbook H6-1 can be utilized where possible.
FIGURE AND INDEX NUMBERS
Items in this section are referenced by figure and index
numbers to the illustrations.
This mechanical parts list is indented to indicate item re-
lationships. Following is an example of the indentation sys-
tem used in the description column.
12 3 4 5 Name & Description
Assembly and/or Component
Attaching parts for Assembly and/or Component
END ATTACHING PARTS
Detail Part of Assembly and/or Component
Attaching parts for Detail Part
END ATTACHING PARTS
Parts of Detail Part
Attaching parts for Parts of Detail Part
END ATTACHING PARTS
Attaching Parts always appear in the same indentation
as the item it mounts, while the detail parts are indented to
the right. Indented items are part of, and included with, the
next higher indentation.
Attaching parts must be purchased separately, un-
less otherwise specified.
ABBREVIATIONS
Abbreviations conform to American National Standards
Institute Yl.l
11-1

Tektronix 2465B Specifications

General

Brand	Tektronix
Model	2465B
Category	Test Equipment
Language	English