Specifications
AFG3000 Series Quick Start User Manual
65
Specifications
This section contains the specifications for the AFG3000 Series Arbitrary/Function Generators. All specifications are
guaranteed unless noted as “typical”. Typical specifications are provided for your convenience but are not guaranteed.
Specifications that are marked with ✔ symbol are checked in Performance Verification section of the service manual, an
optional accessory.
All specifications apply to the arbitrary/function generator unless noted otherwise. These specifications are valid under
three conditions:
■ The arbitrary/function generator must have been calibrated/adjusted at an ambient temperature between +20 ° C and
+30 ° C.
■ The arbitrary/function generator must have been operating continuously for 20 minutes within the specified operating
temperature range.
■ The instrument must be in an environment with temperature, altitude, and humidity with the operating limits described
in these specifications.
Electrical
Operating Mode
Run Mode Continuous, Modulation, Sweep, and Burst
Burst Count 1 to 1,000,000 cycles or Infinite
Internal Trigger Rate 1.000 ms to 500.0 s
Waveforms
Standard Sine, Square, Pulse, Ramp, More (Sin(x)/x, Noise, DC, Gaussian, Lorentz, Exponen-
tial Rise, Exponential Decay, and Haversine)
Arbitrary Waveform AFG3021/AFG3022 AFG3101/AFG3102 AFG3251/AFG3252
Waveform Length 2 to 65,536 2 to
16,384
>16,384
to 131,072
2 to
16,384
>16,384
to 131,072
Sampling Rate 250MS/s 1GS/s 250MS/s 2GS/s 250MS/s
Resolution 14 bits
Non-volatile Waveform Memory 4
Frequency AFG3021/AFG3022 AFG3101/AFG3102 AFG3251/AFG3252
Sine
1
1 µHz to 25 MHz 1 µHz to 100 MHz 1 µHz to 240 MHz
Square 1 µHz to 12.5 MHz 1 µHz to 50 MHz 1 µHz to 120 MHz
Pulse 1 mHz to 12.5 MHz 1 mHz to 50 MHz 1 mHz to 120 MHz
Ramp, Sin(x)/x,
Gaussian, Lorentz,
Exponential Rise,
Exponential Decay,
Haversine
1 µHz to 250 kHz 1 µHz to 1 MHz 1 µHz to 2.4 MHz
Arbitrary 1 mHz to 12.5 MHz 1 mHz to 50 MHz 1 mHz to 120 MHz
To Next Page
Loading...
Need help?
General
