Display Wavefor
morTraceData
5. Push Bandwidth
, and select the desired
bandwidth from the resulting side-bezel
menu.
The set choice
s are: Full, 250 MHz, and
20 MHz. Additional choices may appear,
depending on the probe that you use.
Select Fu ll t
o set the bandwidth to the full
oscilloscope bandwidth.
Select 250 MHz to set the bandwidth to
250 MHz.
Select 20 MHz to set the bandwidth to
20 MHz.
6. Push Label to create a label for the channel.
(See page 51, Labeling Channels and
Buses.)
7. For some types of probes, you can push
this butt
on to instruc t the oscilloscope to
perform an AC calibration on the entire
signal path from the probe tip to the specific
oscillo
scope channel. This can result in a
flatter frequency response over the entire
frequency range.
8. Push Mor
e to access additional side-bezel
menus.
Fine Scale
Offset
Position
Prob
e
Setup
9. Select
Fine Scale to enable multipurpose
knob a to make fine vertical scale
adjustments.
Desk
ew
10. Select Offset to enable multipurpose knob a
to make vertical offset adjustments.
On t
he side-bezel menu, choose Set to 0 V
to set the vertical offset to 0 V.
For more information on offset, see Quick
Ti
ps. (See page 105, Quick Tips.)
MDO4000 Series Oscilloscopes User Manual 103
To Next Page
Loading...
Need help?
General
