Tektronix MDO4104-3 User Manual

Display Wavefor
morTraceData
2. Push the lower
-bezel D15–D0 menu item.
D15 – D0
On/Off
Thresholds Edit Labels MagniVu
On |
Off
Height
S |ML
3. Push the side-bezel Select button.
Select
(a) D0
(b) 1.04 div
Display
On|Off
Turn on
D7–D0
Turn on
D15–D8
4. Turn multipurpose knob a to select the
channel t
o move.
5. Turn multipurpose knob b to mov e the
selected channel.
NOTE. The display of the channel (or group)
only moves after you stop rotating the knob.
6. To change the scale (height) of the digital
channels, push the lower-menu Height
button.
NOTE. The S (Small) selection will display
each waveform at 0.2 divisions tall. The M
(Medium) selection will display each waveform
at 0.5 divisions tall. The L (Large) selection will
display each w aveform at 1 division tall. L only
works if there is enough room in the display to
display the waveforms. You can display up to 10
L waveforms at one time.
7. You can label individual digital channels for
easier identification. (See page 51, Labeling
Channels and Buses.)
MDO4000 Series Oscilloscopes User Manual 107

Tektronix MDO4104-3 Specifications

General

Brand	Tektronix
Model	MDO4104-3
Category	Test Equipment
Language	English