Tektronix MDO4104-3 User Manual

Get Acquainted w
ith the Instrument
5. Device. Use the U SB 2.0 High speed
device port to control the oscilloscope
through USBTM
CorGPIBwitha
TEK-USB-488 Adapter. The USBTMC
protocol allows USB devices to
communicate
using IEEE488 style
messages. This lets you run your G PIB
software applications on USB hardware.
Also, use the
USB port to connect a
PictBridge-compatible printer to the
oscilloscope.
6. Host. Use the U SB 2.0 high speed host
ports (two
on the rear-panel and one on
the front) to take advantage of USB flash
drives and printers.
7. Power input. Attach to an AC power line
with inte
gral safety ground. (See page 5,
Operating C onsiderations .)
MDO4000 Series Oscilloscopes User Manual 49

Tektronix MDO4104-3 Specifications

General

Brand	Tektronix
Model	MDO4104-3
Category	Test Equipment
Language	English