■
The Help button opens a side menu where you can access the Tektronix
Courseware lab exercise functions See Courseware on-instrument education
and training on page 168 and Help Everywhere on-screen settings and
measurements help (See Getting on-screen help for settings - Help
Everywhere on page 33.)
■
The Function button opens a side menu where you can select optional
analysis functions (when available with future software), the Scope Intro
oscilloscope theory and feature tour (See The Scope Intro function on
page 36).
■
The Autoset button automatically sets the vertical, horizontal, and trigger
controls to acquire and display a usable, stable waveform.
■
The Single button takes a single waveform acquisition record.
NOTE. Pushing Single stops the oscilloscope continuous signal acquisition
mode.
■
The Run/Stop button toggles the oscilloscope between continuously
acquiring waveforms (Run) and stopping all waveform acquisitions (Stop).
■
The File Save button (located above the side menu buttons) performs an
immediate preset save operation. Use the Save/Recall menu to set the save
action to perform when the save button is pushed
■
The Menu On/Off button (located below the side menu buttons) clears
displayed menus from the screen. This button also turns on and off the
display of the measurements readouts and the FFT signal settings.
Appendices
178 TBS2000B Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
