Setting the acquisition mode
Use the acquisition mode to set how the oscilloscope uses the sampled data
points in each acquisition interval to create and display a waveform. See
Acquisition mode concepts on page 39.
1. Push Acquire.
2. Push the Mode side-menu button.
3. Turn the Multipurpose knob to select a mode (Sample, Peak Detect, Hi res,
Average), then click the Multipurpose knob to enable that mode.
4. If you select Average, use the Multipurpose knob to select of how many
acquisitions to average to create the waveform.
Acquisition setup
74 TBS2000B Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
