Tektronix TDS7054 User Manual

Appendix B: Automatic Measurements Supported
B-8
CSA7000 Series, TDS7000 Series, & TDS6000 S eries Instruments User Manual
The T1 values are vertical and horizontal values associated with the leftmost
crossing point. These areas are used to establish the following directions:
H TCross1
mean
, the horizontal mean of the left crossing point at TC ross
1
H TCross1
sigma
, the horizontal standard deviation of the left crossing point
at TCross
1
H TCross1
p-p
, the horizontal peak-to-peak deviation of the left crossing point
at TCross
1
H PCross1
mean
, the vertical mean of the left crossing point at PCross
1
The T2 values are vertical and horizontal values associated with the rightmost
crossing point. These areas are used to establish the following directions:
H TCross2
mean
, the horizontal mean of the right crossing point at TC ross
2
H TCross2
sigma
, the horizontal standard deviation of the right crossing point
at TCross
2
H TCross2
p-p
, the horizontal peak-to-peak deviation of the right crossing point
at TCross
2
The duty cycle distortion (DCD) values are horizontal values associated with the
rightmost crossing point at 50% of the eye height. These areas are used to
establish the DCD
p-p
, the horizontal peak-to-peak deviation of the left crossing
point at half the height of the eye.
T1 Values
T2 Values
DCD Values

Tektronix TDS7054 Specifications

General

Brand	Tektronix
Model	TDS7054
Category	Test Equipment
Language	English