To Next Page

To Previous Page

Module Removal

Step 1 – Open the EVOLUTION

controller door and control panel to access the

Figure 11

internal components.

Step 2 – Hold the module as shown in Figure 11. Press the retaining tab while pulling

the top of the module away from the cabinet, then lift the module out of

the controller.

Battery Installation

+–

Figure 12

e EVOLUTION

AG controller uses a 9-VDC battery for arm-chair programming.

Step 1 – Open the EVOLUTION

AG controller door and control panel to access the

internal components.

Step 2 – Locate the battery compartment at the back of the control panel.

Step 3 – Align the polarity (– and +) of the battery then slide it into the battery

compartment as shown in Figure 12.

Note: You may need to pull the battery tab forward to align the battery properly.

Toro EVOLUTION User Manual

Questions and Answers: