23
Maintenance
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After first 10 hours
• Inspect the PTO and cutting unit belts.
• Torque the wheel lug nuts.
• Inspect the engine fan belt.
After first 50 hours
• Change the engine oil and filter.
• Check the electric deck clutches adjustment.
• Check the electric PTO clutch adjustment.
• Check the engine RPM (at idle and full throttle).
• Change the hydraulic oil filter.
Every 50 hours
• Lubricate all grease fittings.
• Check the cutting unit gear box oil level.
• Check the rear axle oil level (4wd).
Every 100 hours
• Change the engine oil and filter.
• Check the battery level/cable connections.
Every 200 hours
• Inspect the cooling system hoses.
• Inspect the PTO and cutting unit belts.
• Check the electric deck clutches adjustment.
• Check the electric PTO clutch adjustment.
• Torque the wheel lug nuts.
Every 400 hours
• Service the air cleaner.
1
• Change the fuel filter.
• Check the front transaxle oil level.
• Inspect the fuel lines and connections.
• Check the engine RPM (at idle and full throttle).
• Change the rear axle oil (4wd).
Every 800 hours
• Inspect the engine fan belt.
• Inspect the engine timing belt.
2
• Drain and clean the fuel tank.
• Change the hydraulic oil
• Change the hydraulic oil filter.
• Change the front transaxle oil
• Pack the rear axle bearings (2wd).
• Change the bidirectional clutch fluid (4wd).
• Check the rear wheel toe-in.
Every 1500 hours or
2 years, whichever
occurs first
• Replace moving hydraulic hoses.
• Replace safety switches.
• Flush the cooling system and replace fluid.
• Replace PTO belts and cutting deck belts.
1
If the indicator shows red
2
Replace the timing belt if worn, cracked, or oil soaked. A new timing belt should be installed any time the belt is removed or loosened.
Important Refer to your engine operator’s manual for additional maintenance procedures.
To Next Page
Loading...
Need help?
General
