Toro Workman MDX User Manual

Accessing the Hood
Raising the Hood
1. Lift up the handle of the rubber latches on each
side of the hood ( Figure 21 ).
g312721
Figure 21
2. Raise the hood.
Closing the Hood
1. Gently lower the hood.
2. Secure the hood by aligning the rubber latches
onto the latch anchors on each side of the hood
( Figure 21 ).
Lubrication
Greasing the Front Wheel
Bearings
Service Interval : Every 300 hours
Grease specication: Mobilgrease XHP™-222
Removing the Hub and Rotor
1. Lift the front of the machine and support it with
jack stands.
2. Remove the 4 lug nuts that secure the wheel
to the hub ( Figure 22 ).
g033046
Figure 22
1. Hub 3. Lug nut
2. Wheel
3. Remove the ange-head bolts (3/8 x 3/4 inch)
that secure the bracket for the brake assembly
to the spindle and separate the brake from the
spindle ( Figure 23 ).
Note: Support the brake assembly before
proceeding to the next step.
30

Toro Workman MDX Specifications

General

Brand	Toro
Model	Workman MDX
Category	Utility Vehicle
Language	English