EasyManuals Logo
Home>Toro>Utility Vehicle>Workman MDX

Toro Workman MDX User Manual

Toro Workman MDX
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
Storage
Storage Safety
Shut of f the machine, remove the key , and wait
for all movement to stop before you leave the
operator s position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
Do not store the machine or fuel container where
there is an open ame, spark, or pilot light, such
as on a water heater or other appliance.
Storing the Machine
Service Interval : Every 200 hours —Inspect the
service and parking brakes.
Every 400 hours —V isually inspect the brakes
for worn brake shoes.
After the rst 50 hours
Every 600 hours/Y early (whichever comes rst)
1. Position the machine on a level surface, engage
the parking brake, shut of f the engine, and
remove the key .
2. Clean dirt and grime from the entire machine,
including the outside of the engine.
3. Inspect the brakes; refer to Inspecting the
Brakes ( page 50 ) .
4. Service the air cleaner; refer to Servicing the Air
Filter ( page 33 ) .
5. Seal the air-cleaner inlet and the exhaust outlet
with weatherproof tape.
6. Change the engine oil; refer to Servicing the
Engine Oil ( page 35 ) .
7. Flush the fuel tank with fresh, clean fuel.
8. Secure all fuel system ttings.
9. Check the tire pressure; refer to Checking the
T ire Pressure ( page 17 ) .
10. Check anti-freeze protection and add a 50/50
solution of water and anti freeze as needed for
expected minimum temperature in your area.
1 1. Remove the battery from the machine and fully
charge the battery; refer to Charging the Battery
( page 43 ) .
Note: Do not connect the battery cables to the
battery posts during storage.
Important: The battery must be fully
charged to prevent it from freezing and being
damaged at temperatures below 0°C (32°F).
A fully charged battery maintains its charge
for about 50 days at temperatures lower than
4°C (40°F). If the temperatures will be below
4°C (40°F), charge it every 30 days.
12. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
13. Paint all scratched or bare metal surfaces.
Note: Paint is available from your Authorized
Service Dealer .
14. Store the machine in a clean, dry garage or
storage area.
15. Cover the machine to protect it and keep it clean.
55

Table of Contents

Other manuals for Toro Workman MDX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro Workman MDX and is the answer not in the manual?

Toro Workman MDX Specifications

General IconGeneral
BrandToro
ModelWorkman MDX
CategoryUtility Vehicle
LanguageEnglish

Related product manuals