Toro Workman MDX User Manual

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description
Qty .
Use
Steering wheel
1
Cover
1
1
W asher (1/2 inch)
1
Install the steering wheel (TC models
only).
2
No parts required
–
Connect the battery (TC models only).
3
No parts required
–
Check the uid levels and tire pressure.
4
No parts required
–
Burnish (break-in) the brakes.
Operator's Manual
1
Engine owner's manual 1
Registration card 1
Predelivery Inspection Form 1
Certicate of Quality
1
5
Key 2
Read the Operator's Manual and view
the setup material before operating the
machine.
Note: Determine the left and right sides of the machine from the normal operating position.
1
Installing the Steering
Wheel
TC Models Only
Parts needed for this procedure:
1
Steering wheel
1
Cover
1
W asher (1/2 inch)
Procedure
1. If the cover is installed, remove it from the hub
of the steering wheel ( Figure 3 ).
2. Remove the locknut (1/2 inch) from the steering
shaft ( Figure 3 ).
3. Slide the steering wheel and washer (1/2 inch)
onto the steering shaft ( Figure 3 ).
4. Secure the steering wheel to the shaft with the
locknut (1/2 inch) and tighten it to 27 to 34 N∙m
(20 to 25 ft-lb).
5. Install the cover on the steering wheel ( Figure 3 ).
g033840
Figure 3
1. Cover 4. Steering wheel
2. Locknut (1/2 inch) 5. Steering shaft
3. W asher (1/2 inch)
9

Toro Workman MDX Specifications

General

Brand	Toro
Model	Workman MDX
Category	Utility Vehicle
Language	English