New PIN Code functions. You can use these functions after entering
the correct PIN code.
Entering the Pl N code
1. Press MENU, and then press • or • until the LOCKS menu
appears.
LOCKS
V CHIP
ENABLE BLOCKING OFF
TV RATING
MPAA RATING
BLOCKING OPTION
CH LOCK
VIDEO LOCK OFF
FRONT PANEL LOCK OFF
NEW PIN CODE
2. Press • or • to display the PIN code entering mode.
• Factory Reset status:
Set your 4-digit code by pressing
the Number buttons (0-9), and
then press ENTER.
• When the PIN code is already stored:
Pressthe Number buttons (0-9) to enter
the 4-digit PIN code usedfor blocking
channels, and then press ENTER.
@ LOCKS
BLOCKING RESET
@ LOCKS
BLOCKING ACTIVE
If a wrong PIN code is entered, the message "Incorrect" appears.
Enter the code again, and then press ENTER.
If you cannot remember the PIN code, while in the PIN code
entering mode, press the RECALL button four times within five
seconds. The PIN code will be released (Blocking Reset status
restored).
®@0®@@
LOCKS
MPAA RATING
BLOCKING OPTION
CH LOCK
VIDEO LOCK OFF
FRONT PANEL LOCK OFF
NEW PIN CODE
Continue to set each item following the steps on the next page.
/ENTER
RECALL
35