7
4400 Series Installation and Operation Manual – 64527-008
3.4 Transporting
WARNING
DO NOT tilt the UPS more than 10° from upright position.
Tilting the UPS more than 10° may cause crushing, trapping or other
personal injuries.
CAUTION
DO NOT transport, move, store, or place the UPS on its side.
Excessive force applied from heavy components inside may damage
the UPS.
Avoid vibration or shock exceeding 0.5 g.
Failing to observe this precaution may cause damage to the UPS.
Tools used to remove packaging materials may cause damage to the
UPS.
DO NOT install the UPS where water may fall on or enter it.
Water may cause electrical shock, personal injury or UPS failure.
DO NOT push or pull on the sides of the packaging or the
UPS to move it. Always use a crane, forklift, or pallet jack for
transporting and positioning the UPS.
Pushing/pulling on the sides of the unit to move it may result in damage
to the UPS.
To Next Page
Loading...
Need help?
General