8
4400 Series Installation and Operation Manual – 64527-008
4 Unpacking
4.1 General Instructions
Unpack the UPS indoors on a paved oor. The UPS should be as close as possible to its nal location. Allow enough space
for forklift operations to unpack the UPS from the packing crate. Then remove the crate. Properly dispose of the crate.
Points to observe:
• Retain all small articles during unpacking and installation.
• Make sure that exterior paint is not scratched and that the UPS cabinet is not damaged before uncrating.
• DO NOT damage the UPS when using tools to remove packaging materials.
• If provided, DO NOT remove the protective plastic sheet cover until installation.
• Do not remove the protective fan covers over the fans until UPS start up. The fan covers should be removed
by factory authorized personnel. Packing materials should be disposed by the appropriate means.
• Immediately report any abnormalities to Toshiba Customer Support Center or an authorized representative.
• Retain the packing rails for ooading the UPS from the shipping pallet, and for nal UPS installation.
4.2 Unpack the 15-30kVA Model UPS (with Casters)
NOTE: The 4400 UPS is equipped with casters and leveling feet. It is attached to the shipping pallet by two un-
.
CAUTION
TOP HEAVY EQUIPMENT. THIS EQUIPMENT WILL TIP OVER EASILY
UNTIL FIXED IN PLACE.
Lift and move carefully, and only with adequate equipment and trained
personnel. IMPROPER LIFTING CAN RESULT IN INJURY OR DEATH.
To Next Page
Loading...
Need help?
General