Using the Remote with VCR or Cable TV Converter
• To control TOSHIBA VCR, first set the TV/CABLENCR switch to "VCR" position. The buttons shown below will then
control the VCR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program your Remote to control it.
Details are on page 11.
• To control a cable TV converter, this Remote Control must be programmed to recognize the brand of your converter.
See page 11.
Set the TV/CABLENCR switch to "CABLE" position whenever you control the cable TV converter.
Aim at the VCR or cable TV converter
m
m
m
TV/CABLENCR switch
"CABLE" : To control cable
TV converter
"VCR" : To control VCR
Channel number buttons
Press the numbers
desired for direct access.
STOP button
Press to stop the tape.
REC button
Press to start recording.
TV/VCR button
Press to select the TV mode
to view one program while
recording another program.
J
EDS ADV
REC TV/VCR REW FF
TOSHIBA
-- POWER button
Press the button to turn the
VCR (or converter) on.
Press again to turn off.
CHANNEL A/• buttons
Press • button to select next
higher channel.
Press • button to select next
lower channel.
CH RTN button
See page 18.
PLAY button
Press to begin tape playback.
FF button
Press to rapidly advance the tape. In
playback mode, press to view the picture
moving rapidly in forward direction.
REW button
Press to rewind the tape.
In playback mode, press to
view picture moving rapidly in
reverse.
Shaded buttons can be used to control
the cable TV converter.
10
To Next Page
Loading...
Need help?
General
