Programming Channel Memory
The channel memory is the list of TV channel numbers your TV will stop on when you press the CHANNEL • or • button.
First, use the TV/CABLE and CH PROGRAM functions to preset all active channels in your area automatically.
If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired channels,
:HANNEL •/!!' 1 Press POWER to turn on the TV.
2 Press MENU repeatedly to display the
SET UP menu on the screen.
3 Press ADV repeatedly until "TV/CABLE"
is displayed in magenta.
MENU
ADV -
OO
POWER
CHANNEL
•/•
ADV +
4
2
* This TV receives the following TV
signals:
1. TV: TV broadcast signals.
(VHF channels 2 through 13 and
UHF channels 14 through 69) 3
2. STD CABLE: Standard cable TV
signals.
3. HRC CABLE: Harmonic Related Carrier
cable TV signals.
4. IRC CABLE: Incremental Related
Carrier cable TV signals.
If you are not sure what CABLE system
they are using, consult your local cable 4
company.
Press - or + until the mode that corre-
sponds to your TV signal system is
displayed in magenta.
Each time you press the button, the TV*,
STD CABLE*, HRC CABLE* or IRC CA-
BLE* mode will be selected in order.
r-
SET UP
TV/CABLE
TO SELECT ITEM PUSH ADV
TO CONTROL PUSH - +
TV
STD CABLE
HRC CABLE
IRC CABLE
TO SELECT PUSH - +
Select"CH PROGRAM"following steps 2
and 3 above.
SET UP
',4! _ •
CH PROGRAM
"" vC_< JT:
TO SELECT ITEM PUSH ADV
TO CONTROL PUSH - +
Press - or + to start channel program-
ming.
The TV will automatically cycle through
all the TV or CABLE channels on the
mode selected by the TV/CABLE function,
and store active channels in the channel
memory.
When channel programming is complete,
you will see the message at the right.
CH PROGRAM
4,
TV 12
CH PROGRA_IvIING
COMPLETED
TV 4
Press CHANNEL • or • to make sure the channel programming has
been done properly.
!!iii_iii_ii_iiii_iii!!i!
!!!iiiiliiiii !iiii!
o
E
i
p,
J=
o
O_
.i
E
E
P
o
.i
i
i
e-
€.
o
€
M.
e-
15
To Next Page
Loading...
Need help?
General
