3 Tests and Diagnostics 3.30 Sound Test program
3-90 [CONFIDENTIAL] QOSMIO F20 Maintenance Manual (960-526)
(2) Audio CD
Insert an audio CD and the following menu appears in the display.
CD/DVD TEST IN PROGRESS XXXXXXXX
xxxxxxx DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] : test end
[Ctrl]+[C] : key stop
SUB-TEST : XX
PASS COUNT : XXXXX ERROR COUNT : XXXXX
WRITE DATA : XX READ DATA : XX
ADDRESS : XXXXXX STATUS : XXX
CD Sound track number (01-98 : Track) ?
Drive # = 0, ATAPI status =00
Command = XX
[[Block address = XXXXXXXX]]
[[Block length = XXXXXXXX]]
Final : Block address = XXXXXXXX
Select the track number you want to test and press Enter twice.
The following message appears in the display and selected track is played.
Play start CD sound !
Press any key <play stop>
After pressing any key, the music stops and the display returns to the selection menu of the track
number.
NOTE: When the CD-ROM test is executed, [All Devices] must be selected in the
“Device Config.=” of the BIOS SETUP. If the [All Devices] is not selected,
music can not be played.
3.30.4 CD Sound (Legacy)
To execute the CD Sound (Legacy) test, select 4 and press Enter.
CAUTION: Sound (Legacy) test is not supported in this model.
To Next Page
Loading...
Need help?
General