4 Replacement Procedures 4.7 Switch membrane
4-22 [CONFIDENTIAL] QOSMIO F20 Maintenance Manual (960-526)
4.7 Switch membrane
Removing the switch membrane
The following describes the procedure for removing the switch membrane (See Figure 4-12).
1. Disconnect the switch membrane cable from the connector CN9650 on the system
board.
2. Remove the following screw fixing the membrane switch.
? M2.5?4B FLAT BIND x1
3. Slide the switch membrane to the arrow direction and remove it.
Figure 4-12 Removing the switch membrane
Installing the switch membrane
The following describes the procedure for installing the switch membrane (See Figure 4-12).
1. Slide the switch membrane to install and secure it with the following screw.
? M2.5?4B FLAT BIND screw x1
2. Connect the switch membrane cable to the connector CN9650 on the system board.
Switch membrane
M2.5x4B FLAT BIND
CN9650
Switch membrane cable
To Next Page
Loading...
Need help?
General