4.6 Keyboard 4 Replacement Procedures
QOSMIO F20 Maintenance Manual (960-526) [CONFIDENTIAL] 4-21
Installing the keyboard
The following describes the procedure for installing the keyboard (See Figure 4-9 to 4-11).
1. Turn the keyboard upside down and place it on the palm rest as its face down.
Connect the keyboard flexible cable to the connector CN3200 on the system board.
2. Install the keyboard support plate from the left side (opposite to the screw hole) and
secure it with the following screw.
? M2.5?6B FLAT BIND x1
3. Turn the keyboard face up and put it on the computer. Make sure that there is no
space between the keyboard and the computer.
4. Secure the keyboard with the following screws.
? M2.5?4B FLAT BIND x2
5. Install the speaker cover, pressing it.
To Next Page
Loading...
Need help?
General