4 Replacement Procedures 4.10 RTC battery
4-32 [CONFIDENTIAL] QOSMIO F20 Maintenance Manual (960-526)
4.10 RTC battery
Removing the RTC battery
The following describes the procedure for removing the RTC battery (See Figure 4-21).
1. Disconnect the RTC battery harness from the connector CN9990 on the system board.
2. Remove the RTC battery. (The RTC battery is adhered with double-sided tape.)
Figure 4-21 Removing the RTC battery
Installing the RTC battery
The following describes the procedure for installing the RTC battery (See Figure 4-21).
1. Install (adhere) the RTC battery on the slot.
2. Connect the RTC battery harness to the connector CN9990 on the system board.
RTC battery
CN9990