2 Troubleshooting Procedures 2.3 Power Supply Troubleshooting
2-6 [CONFIDENTIAL] QOSMIO F20 Maintenance Manual (960-526)
2.3 Power Supply Troubleshooting
The power supply controller controls many functions and components. To determine if the
power supply is functioning properly, start with Procedure 1 and continue with the other
Procedures as instructed. The procedures described in this section are:
Procedure 1: Power Status Check
Procedure 2: Error Code Check
Procedure 3: Connection Check
Procedure 4: Charging Check
Procedure 5: Replacement Check
Procedure 1 Power Status Check
The following icons indicate the power supply status:
? Battery icon
? DC IN icon
The power supply controller displays the power supply status with the Battery icon and the
DC IN icon as listed in the tables below.
Table 2-1 Battery icon
Battery icon Power supply status
Lights orange Battery is charged and the external DC is input. It has no
relation with ON/OFF of the system power.
Lights green Battery is fully charged and the external DC is input. It has
no relation with ON/OFF of the system power.
Blinks orange
(even intervals)
Battery level is low while the system power is ON.
Blinks orange once
(at being switched on)
System is driven by only a battery and the battery level is
low.
Doesn’t light Any condition other than those above.
To Next Page
Loading...
Need help?
General