-153-
5.4.1 ip
The ip command is used to view or configure the IP address and subnet mask of the interfaces. View
command can be used in both User EXEC Mode and Privileged EXEC Mode while configuration
function can be only used in Privileged EXEC Mode.
TP-LINK > ip get lan
Lan Ip: 192.168.0.1
Lan Mask: 255.255.255.0
Get the configuration
information of LAN port.
TP-LINK # ip set lan address 192.168.0.20
Set the LAN IP address of the
Router as 192.168.0.20.
Operation succeeded!
Indicates the operation is
successful. It will be
prompted if an error occurs.
TP-LINK # ip set lan mask 255.255.0.0
Set the LAN subnet mask of
the Router as 255.255.0.0.
5.4.2 ip-mac
The ip-mac command is used to view or configure the current IP-MAC Binding mode. View command
can be used in both User EXEC Mode and Privileged EXEC Mode while configuration function can be
only used in Privileged EXEC Mode. The IP-MAC Binding mode includes two types: normal mode and
restrict mode.
TP-LINK > ip-mac get mode
Ip-mac Bind Mode: normal
Get the current IP-MAC
binding mode.
TP-LINK # ip-mac set mode restrict
Set the current IP-MAC
binding mode to restrict
mode.
5.4.3 sys
The sys command is used for system management, including Backup and Restore, Factory Default,
Reboot, Firmware Upgrade and so on.
To Next Page
Loading...
Need help?
General
