BAS-SVX45F-GB 13
Installation
This section describes how to install Tracer UC600 onto a DIN rail and set rotary switches.
Mounting and Removing the Tracer UC600 Controller
The Tracer UC600 controller should be properly mounted on a DIN rail.
To mount or remove the controller from the DIN rail, follow the illustrated instructions in Figure 4
and Figure 5, p. 14. If using a DIN rail from another manufacturer, follow the recommended
installation procedures that accompany it.
Important: When mounting the controller in a control cabinet, provide adequate spacing
between modules to allow for ventilation and heat dissipation.
NOTICE:
Avoid Equipment Damage!
Do not use excessive force to install the controller on the DIN rail. Excessive force could
result in damage to the enclosure.
Figure 4. Mounting the Tracer UC600
To mount the controller:
1. Hook device over top of DIN rail.
2. Gently push on lower half of device in
the direction of arrow until the release
clip clicks into place.
Table 1. DIN unit width measurements
Device Device Width (mm)
DIN Unit Width
(1 unit = 18 mm)
Tracer SC system controller 143.6 mm 8
Tracer UC400 controller 143.6 mm 8
Tracer UC600 controller 215.9 mm 12
Tracer UC800 controller 71.6 mm 4
Tracer XM30 expansion module 53.6 mm 3
Tracer XM32 expansion module 71.6 mm 4
Tracer XM70 expansion module 215.9 mm 12
PM014 power supply module 107.6 mm 6
Tracer BACnet terminator 35.6 mm 2
DIN Unit Width
The following table provides DIN unit width measurements for Trane devices.
To Next Page
Loading...
Need help?
General
