Pre-Installation Planning and Requirements
iSTAR Ultra Installation and Configuration Guide 2–3
Ensure that the mounting site is ready to accommodate the iSTAR dimensions.
iSTAR Ultra Wall Mount Dimensions
Table 2-1 on page 2-3 lists the iSTAR Ultra Cabinet Wall Mount Dimensions.
Wall Mount Hardware
Table 2-2 on page 2-3 lists the hardware recommended for wall mounting the iSTAR Ultra.
The hardware listed in Table 2-2 is not included with the iSTAR Ultra.
Table 2-1: Cabinet (Wall Mount Dimensions
Item Dimension/Location
Weight 26.5 lb (12.02 kg)
Height 21.5 in. (54.61 cm)
Width 25 in. (63.5 cm)
Depth 5 in. (12.7 cm)
Upper Mounting
Holes
10 in. (22.86 cm) center to center to center. The outer two mount holes are keyhole type.
Bottom three
Mounting Holes
Directly below the upper mount holes.
You must consult a Structural Engineer when mounting to meet local
Seismic requirements.
Consult a structural expert for mounting configurations not listed in
Table 2-1.
Table 2-2: Wall Mount Hardware Recommendations
Screw Size (Minimum)
Anchor Type
Screw Type
(Pan Head)
Wood Studs,
Plywood Wall
Drywall Plaster
Board
Concrete,
Brick, or Block
Wall
Minimum
Number of
Screws
No Anchor Wood Screws #10 x 1-1/4 inch 6 X #10,
4 x #12
No Anchor Concrete Screws #10 x 1-1/4 inch 4
Super Hold
Plastic Anchors
Wood, sheet metal
screws
#10 x 1-1/4 inch #10 x 1-1/4 inch 6
Toggle Bolts (bolt included) (only for
keyholes)
10-24 x 1-1/4 inch 10-24 x 1-1/4 inch 2
Hollow Wall
Anchor
(screw included) 10-24 x 1-1/4 inch 10-24 x 1-1/4 inch 6
To Next Page
Loading...
Need help?
General
