Programable DC Electronic Load User Manual
28
List mode Parameters Description
Group 1~60
Set the group number of the list test
parameters for easy calling.
Step 1~16 Set the step of the list test.
Repeat 0~99999
Set the number of repetitions of each
measurement in the current mode.
Mode Continus/Trig/Con+Err/Trig+Err
Set the switching method of each step
and the stopping method.
<Group>
The Flash of the electronic load can save 60 groups of list modes. When setting the list
parameters, please set a reasonable group number first.
1. Press function key to enter [List] mode, move the cursor to [Group] by rotating the
knob, and press the Enter key or the knob to change the group number value
from yellow to white. Input the appropriate group number value through the numeric
keyboard, and then press the Enter key after setting the value. Used/unuse
will be displayed behind the number, indicating whether the group number has been
used.
2. If the set group number is already in use, used will be displayed, and the original
group number parameters will be overwritten when the test file is saved.
3. If the group number has not been used, unuse will be displayed. It will create a new
list file after the setting.
4. Select the storage location (Flash memory/U disk) before saving and press the save
button to finish saving; record the set group number so that it can be called next time.
<Step>
After setting the group number, rotate the knob to move the cursor to [Step] to set the
number of steps for the list test, up to 16 steps can be set.
<Repeat>
Rotate the knob to move the cursor to [Repeat] to set the number of repetitions for each
measurement in the current mode. Users can set up to 99999 times.
<Mode>
Rotate the knob to move the cursor to [Mode] to set the current operating mode. Err
means that the load will automatically stop loading if there is an abnormality during
operation.
There are four options for setting the operating mode: Continues/Trig/Continues
+Err/Trig+Err.
To Next Page
Loading...
Need help?
General
