Getting started 9
Charging the batteries
¤ Charge the batteries fully prior to first use in the base
station/charging cradle. The batteries are fully charged
when the power icon disappears from the display.
Attaching the belt clip
The handset has notches on each side for attaching the belt clip.
• Attaching the belt clip: Press the belt clip onto the back of the handset
until the tabs on the clip engage in the notches.
• Removing the belt clip: Press the center of the belt clip firmly with your
thumb. Press the nail of the thumb on your other hand up between the
clip and the casing. Slide the clip upwards to remove.
Changing the display language
You can change the display language if the telephone has been set to an incomprehensible language.
¤ Press the middle of the control key .
¤ Press the keys and slowly in succession . . . the language settings
display appears and the set language (e.g. English) is highlighted ( =
selected).
¤ Select a different language: Press the control key until the desired
language is marked in the display, e.g. French press the key on the right
directly underneath the display to activate the language.
¤ To revert to idle status: Press the End call key and hold
Setting the date and time
Set the date and time so that the date and time can be assigned correctly to incoming calls and to enable
the alarm to be used.
¤ Press the display key Time
or, if the date and time have already been set:
¤ . . . use to select Settings OK Date/Time OK
The active cursor position flashes . . . use to change the cursor
position . . . use to switch between cursor positions
Enter date:
¤ . . . use to enter the day, month and year in 8-digit format,
e.g. for 15/08/2014.
Enter the time.
¤ . . . use to enter hours and minutes in 4-digit format, e.g.
for 07:15.
To save settings:
¤ Press the display key Save . . . the message Saved is shown on the display
and you hear a confirmation tone . . . the telephone returns to the Settings menu item.
¤ Insert the batteries (for correct
+/- direction, see diagram).
¤ Fit the battery cover from the
top.
¤ Press the cover until it clicks into
place.
To re-open the battery cover:
¤ Insert a fingernail behind the
notch at the top of the cover
and slide the cover downwards.
The handset may only be placed on the designated base station or charging cradle.
The battery may heat up during charging. This is not dangerous.
After a while, the charge capacity of the battery will decrease for technical reasons.
Handsets contained in the package have already been registered to the base station. In the
event that a handset is not registered however (indicated by "Please register handset"), please
contact the administrator.
Date/Time
Date:
8/15/2014
Time:
12:00 AM
Back Save