Unify OpenStage M3 Plus User Manual

10 Putting the handset into service
Putting the handset into service
Checking the package contents
• Handset
•Battery pack
• Accessory pack containing the following:
– Battery cover
– Screw for battery cover
– Allen key
– Attachment clip
– Holder for attachment clip
– Dummy plug (OpenStage M3 and OpenStage M3 Ex only)
– Connector with cord for man down alarm (OpenStage M3 Plus and
OpenStage M3 Ex Plus only)
• Document "Information on Handset"
• Document "Safety Notes"
Removing the protective cover
Installing the charger
The charger is designed for operation in closed, dry rooms within a temperature
range of +5 °C to +45 °C.
Position the charger on a level, non-slip surface.
The phone's feet do not usually leave any marks on surfaces. However, due to
the multitude of different varnishes and polishes used on today's furnishings, the
occurrence of marks on the surfaces cannot be completely ruled out.
1. Connect the flat plug from the power adapter to the charger.
2. Plug the power adapter into the plug socket.
Remove the protective cover from the display before putting
the handset into service.
Please note:
• Never expose the telephone to the influence of heat sources, direct
sunlight or other electrical devices.
• Protect your handset from moisture, dust, corrosive liquids and fumes.
1
2

Unify OpenStage M3 Plus Specifications

General

Brand	Unify
Model	OpenStage M3 Plus
Category	IP Phone
Language	English