Personal alarm functionality 71
Personal alarm functionality
The OpenStage M3 Plus and OpenStage M3 Ex Plus handsets are equipped
with a sensor that allows them to be operated as a PNG-S.
These handsets are referred to below as personal alarm devices with voice com-
munication capability, or by the abbreviation PNG-S.
Alarm statuses
Integrated sensors detect alarm statuses such as:
• Non movement
• Position detection (deviation from the upright position, e.g. the person has
fallen)
• Intense motion (escape)
• Cyclical response monitoring (timed)
• Loss of PNG-S (via pull-away contact with cord)
Terms
Operating modes
The OpenStage M3 Plus and OpenStage M3 Ex Plus handsets can be used as
personal alarm devices with voice communication capability (PNG-S) in Alarm
Mode and PNG Mode. Various settings are performed on the handset for this
purpose, which enable automatic or manual alerting.
The configuration may only be performed by appropriately trained service per-
sonnel for professional use (e.g. in accordance with BGR 139).
A service PIN is used to protect mode activation from unwanted changes by third
parties.
The configuration of the operating modes is described in a separate service
manual.
Alarm sensors
The alarm sensors detect operating states from which alarm situations can de-
velop. The handset can detect and signal automatic alarms. These include non
movement, man down, time, escape and pull cord alarms.
In addition to automatic alarms, there are also manual alarms, which are trig-
gered by means of an alarm key.
To Next Page
Loading...
Need help?
General