Alarm Operation
Automatic Call after Alarm
Follow the same steps to disable the alarm.
Cancel Man-down and No-movement Alarm
A Man-down or No-movement detection can be cancelled before the alarm is sent out.
When the handset enters the warning phase and the message Man-down warning. Cancel?
or No-movement warning. Cancel? appears, do one of the following to cancel the alarm:
• Press OK.
•
Press any key including the wired headset button
18
.
•
Move the handset to an upright position (for Man-down).
19
Delay Man-down and No-movement Alarm Temporarily
You can delay Man-down or No-movement alarm before it is sent. To do this, during the warning
phase press the Mute button and then press Yes to confirm the message Delay MD/NM de-
tection?. The corresponding display icon flashes until the alarm is active again (default 10
min).
This feature can be enabled by the system administrator using the WinPDM/WSG DM. Please
refer to the Configuration Manual, Unify OpenScape WLAN Phone WL4.
Reset Man-down and/or No-movement Alarm
You can reset the alarm that has been triggered, by doing one of the following:
• Move the handset to an upright position (after Man-down).
• Move the handset (after No-movement).
•
Press any button
20
including the wired headset button.
• Press the Mute button if the ALS sounds.
The corresponding icon flashes until the alarm has been reset.
Automatic Call after Alarm
A handset can be set up to call a predefined number after an alarm has been sent, for example
to “112” which is the common emergency call number inside the European Union.
NOTICE: Any ongoing call will be automatically terminated prior to establishing
the automatic call.
Depending on the settings, the call can be established in the following modes:
• Loudspeaking mode — the loudspeaker is turned on.
• Monitor mode
— the loudspeaker is muted and the microphone is on.
• Normal mode
— the call is established in an ordinary call.
18
Except for the bluetooth headset button.
19
Configured by the system administrator.
20
Except for the top button.
A31003-M2000-U109-01-7619, 29/04/2020
OpenScape WLAN Phone WL4, User Manual 43
To Next Page
Loading...
Need help?
General