Front Matter Sageon Micro Power Module Manual
PM990-4207-00, Rev 6
ii
RECEIVING INSTRUCTIONS
and
GENERAL EQUIPMENT INFORMATION
Please Note: For your protection, this product manual should be read and
thoroughly understood before unpacking, installing, using, or servicing the
described equipment.
UNIPOWER, LLC presents all equipment to the delivering carrier securely packed and
ready for transport. Upon acceptance of the equipment from us, the delivering carrier
assumes responsibility for its safe delivery to you. Once you receive the equipment, it is
your responsibility to document any damage to the equipment that was sustained during
transport to you and to file your claim with the carrier promptly and accurately.
PACKAGE INSPECTION
Examine the shipping container for any visible damage: punctures, dents, and any other signs of possible internal
damage.
Describe any damage or shortage on the receiving documents and have the carrier’s representative sign his/her full
name.
If you're receiving freight bill notes that a Tip-N-Tell is attached to your freight, locate the indicator and note the
color of the arrow. If the Tip-N-Tell arrow has turned even partially blue, this means the freight has been tipped in
transport. Make sure the carrier notes this on your receipt before you sign for the freight.
EQUIPMENT INSPECTION
Promptly upon receipt of shipment, open the container and inspect the contents for damage. If it is necessary to
move or otherwise handle the shipment, refer to the next section, Handling, for instructions and warnings.
Unpack the shipment carefully to avoid scratching or otherwise marring the exterior finish. Be careful not to discard
any included equipment, parts, or manuals. If damage is detected, call the delivering carrier to determine
appropriate action. The carrier may require an inspection.
IMPORTANT: If damage is detected, save all shipping material for the carrier’s representative!
If damage is detected, also notify UNIPOWER; contact information is in the Product Support section. UNIPOWER
will determine if the equipment should be returned for repair. If it is determined that the equipment should be
returned to UNIPOWER, ask the delivering carrier to send the packages back to UNIPOWER at the delivering
carrier’s expense. Be sure that the equipment is properly packaged for shipment.
If repair is necessary, UNIPOWER will invoice you for the repair so that you may submit the bill to the delivering
carrier with your claim form.
It is your responsibility to file a claim with the delivering carrier. Failure to properly file a claim for shipping
damages may void warranty service for any physical damages later reported for repair.
HANDLING
The Power Module is moderate in weight. Use sufficient personnel and power equipment to ensure safe handling.
Use extreme care in handling and unpacking the Power Module. Refer to section 3.1 for Mounting the Power Shelf.
To Next Page
Loading...
Need help?
Input Power