Upright MX Series User Manual

31 “Translation of the original instruction”
B-7
4.2.7 Test Drive Speed - Stowed
Position
Instant UpRight specifications require this procedure
to be executed every 250 hours or quarterly,
whichever comes first.
The correct drive function is critical to safe operation
of the machine. The drive function should respond
quickly and smoothly under operator control. In the
entire controllable range of the corresponding
speed, the drive performance should also have no
hysteresis and abnormal noise.
1.Mark two lines at a distance from the ground as
the start and stop lines.
2.Turn the key switch to the platform controller and
pull the red "emergency stop" button on the ground
controller and platform controller to the ON
position.
3.Press the drive function selection button.
4.Select a point on the machine, the point of contact
between the tire and the ground, use as a visual
reference point when the machine passes through
the start and stop lines.
5.The machine is fully driven at the start line. When
the reference point on the machine passes through
the start line, start timing.
6.Continue to maintain the full speed state, when
the reference point on the machine passes through
the stop line, write down the time.
B-8
4.2.8 Test Drive Speed - Raised
Position
Instant UpRight
specifications require this
procedure to be executed every 250 hours or
quarterly, whichever comes first.
The intact drive function is critical to safe operation
of the machine. The drive function should respond
quickly and smoothly under operator control. In the
entire controllable range of the corresponding
speed, the drive performance should also have no
hysteresis and abnormal noise.
1. Mark two lines at a distance from the ground as
the start and stop lines.
2. Turn the key switch to the platform controller
and pull the red "emergency stop" button on
the ground controller and platform controller
to the ON position.
3.Press the drive function selection button.
4. Elevate the platform to about 2 meters height.
5.Select a point on the machine, the point of
contact between the tire and the ground, as a visual
reference point when the machine passes the start
line and stop line.
6.The machine is fully driven at the start line. When
the reference point on the machine passes through
the start line, start timing.
7.Continue to keep the full speed state, until the
reference point on the machine passes through the
stop line, write down the time.

Upright MX Series Specifications

General

Brand	Upright
Model	MX Series
Category	Scissor Lifts
Language	English