65 “Translation of the original instruction”
6. Fault Code
Obey:
The troubleshooting and repair process must be
performed by trained and qualified personnel who
have been trained in the machine.
Damaged or malfunctioning machines should be
marked immediately and stop operation.
Before operating the machine, it must repair all its
damage and malfunction.
Unless otherwise specified, the individual repair
procedures can only be performed if the machine is
in the following configuration:
Place the machine on a solid horizontal surface
The platform is in stowed position
The key switch is in the OFF position and the
key is pulled out
The red "
emergency stop" button for the
ground and platform controllers is in the OFF
position
The wheel is in locked status
The machine has been disconnected from all
external AC power supplies
Read, understand and follow the safety instructions
and operating instructions in the operating
instructions.
Make sure that all necessary tools and test
equipment are ready.
Pay attention to the following hazardous situations
and comply with the prevailing work
practices.
Danger! Risk of injury. When testing or replacing
hydraulic components, always support and fix the
components to prevent movement.
Caution! Risk of electric shock. Exposure to live
circuits can result in death or serious injury. Remove
all rings, watches and other accessories.
Caution! Risk of physical injury. Sprayed out of the
hydraulic oil may penetrate and burn the skin. Slowly
release the hydraulic connection to gradually reduce
the oil pressure. Do not spray or spray oil.
Note! Perform all troubleshooting on a solid, flat
ground.
Note! For some troubleshooting operations, two
people are required for safety reasons.
To Next Page
Loading...
Need help?
General
