61 “Translation of the original instruction”
4-2
5.3.2 Hydraulic Tank
The main function of the hydraulic tank is to
cool, clean and degrade the hydraulic oil during
operation. It utilizes an internal inlet filter for
the pump supply line and is equipped with an
external return line filter.
5.3.2.1Method to Remove the
Hydraulic Tank
Note! Risk of damage to parts. The work
area and surface in which the program will be
executed must be cleaned and there is no
debris that may enter the hydraulic system and
cause serious damage to the component.
Recommended sales repairs.
CAUTION: When removing the hose assembly
or connector and reinstalling it, the O-ring on
the connector and / or hose must be replaced
and set the torque according to the
specifications.
1.Open the hydraulic tank side cover.
2.Remove the drain plug from the hydraulic tank
and drain the oil from the tank thoroughly into
the appropriate container.
Warning! Risk of physical injury. Sprayed out
of the hydraulic oil may penetrate and burn the
skin. Slowly release the hydraulic connection to
gradually reduce the oil pressure. Do not spray or
splash oil.
3.Mark and disconnect the harness on the ground
control box.
4.Remove the ground cont
machine and set it aside.
5.Mark and disconnect the hydraulic hose from
the hydraulic tank and plug it in. Cover the
terminals of the tank and return oil filter with a
lid.
6.Loosen the mounting strap on the hydraulic
tank. Pull the tank holder to the side.
CAUTION: Do not remove the fuel tank.
7.Remove the hydraulic tank from the machine.
Caution! Risk of damage to parts. Do not
tighten the hydraulic tank belt mounting fasteners
during installation.
CAUTION: Before installing, be sure to clean the
hydraulic tank and check for cracks and other
damage.
To Next Page
Loading...
Need help?
General
