3.19 ISOBUS implement control system
The Valtra ISOBUS implement control system (extra equipment) complies with
the ISO 11783 standard.
The system connects together the tractor, the implement and the ISOBUS
terminal, and enables information exchange between these units.
The Valtra ISOBUS implement control system fulfils the Class 2 standard
requirements. It transmits the following information to the implements connected
to the ISOBUS.
• Tractor speed information (radar, wheels and engine)
• Distance and direction
• Rear linkage position
• Power take-off (PTO) status and speed
• Lighting control
The Valtra ISOBUS implement control system provides also electric power for
ISOBUS components (25 A) and electric power for actuators and implements (60
A). The Valtra ISOBUS implement control system can maintain the power for a
maximum of one hour if an implement or the terminal requires so.
NOTE: The main power of the tractor is on for a maximum of one hour after the
ignition switch is turned to the (OFF) position.
GUID-4EF14D40-05D3-41EF-AF2F-FC4B1F40FC42
1. ISOBUS bus extension connector (under the side panel)
2. ISOBUS terminal connector
3. ISOBUS implement connector
4. Valtra C1000 ISOBUS Terminal
3. Operation
- 222 -
To Next Page
Loading...
Need help?
General
