AUTO1 / AUTO2 shifting automatics symbol
The AUTO1 or AUTO2 symbol appears based on the shifting automatics mode in
use. When the shifting automatics is not selected, the symbol is not visible and
the manual shifting is in use.
Speed range symbol
The selected speed range letter (A, B, C, D) is shown in the transmission section.
When changing the speed range, the letter for the requested speed range is
flashing until the selected speed range is engaged.
Automatic traction control symbol
The automatic traction control symbol flashes when automatic traction control is
activated. The symbol is displayed continuously when the desired direction has
been reselected.
3.11.2.3 General information section
The general information section on the A-pillar display shows the basic mode
view. The information shown in the basic mode view changes according to the
driving situation. You can also select one of the views as fixed.
GUID-A684AEC9-9F53-45BD-94D0-DB773C8D0123
1. Service code symbol
2. Power take-off (PTO) symbol
3. Value of selected property
4. AdBlue symbol
5. AdBlue level bar
Driving speed information
In the basic mode view, the tractor symbol and the current driving speed are
shown if the tractor is moving. In the fixed view, they are shown continuously.
The accuracy of the driving speed view is described in the following table.
Driving speed
Accuracy
0.0-9.9 0.1
10.0-14.8 0.2
15 and above 1 (no decimals)
3. Operation
- 160 -
To Next Page
Loading...
Need help?
General
