Vimar Eikon Instruction Handbook

24 - ENGLISH
5.1
Initialising the reader and program-
ming SLAVE smart cards
5. Operation without a MASTER smart
card
This procedure generates a code, associates it with a
selected address in the memory of the reader/programmer
being initialised, and copies it to the desired smart cards.
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1
O
N
2 3 4 5 6 7
5.1.2
Place dip-switch 3 in the OFF position.
5.1.1
Power up the reader.
4.4.7
When the LED turns off, the SLAVE smart
card has been programmed or repro-
grammed.
4.4.8
Remove the SLAVE smart card.
The LED turns green, waiting for other
SLAVE smart cards to program or repro-
gram.
To program additional SLAVE smart cards,
repeat the procedure from step 4.4.6.
4.4.9
To exit the procedure, press the front
button.
The LED switches off.
If no smart cards are inserted for
approximately 15 seconds, the procedure
automatically terminates and the LED
switches off.
Device and access control in the resi-
dential and services sectors:

Vimar Eikon Specifications

General

Brand	Vimar
Model	Eikon
Category	Switch
Language	English